haaga 677 / 697 / 697 plus
57
EN
9. Maintenance and cleaning
WARNING
Risk of cutting due to broken glass, metal
or other sharp edged materials!
When emptying the sweeping container,
cutting injuries may occur due to broken glass,
metal or other sharp edged materials.
•
Wear the prescribed personal protective
equipment!
CAUTION
Health impairments caused by dust
resulting from sweeping!
The inhalation of dusts can endanger the
health.
•
Wear the prescribed personal protective
equipment!
CAUTION
Risk of injury through tipping over of the
push bar!
Tipping over of the push bar may lead to slight
injuries, such as jamming of the finger or
bruising in users or other persons.
•
When carrying the device, hold it so that the
push bar cannot tip over.
CAUTION
Hazard due to cleaning materials!
The agents can contain harmful ingredients
and can thereby cause irritation of the
respiratory tract and the skin.
• Observe the manufacturer's safety data
sheet.
•
Avoid spillage and the formation of fog.
• Do not eat, drink or smoke while working.
•
Avoid contact with skin and eyes.
Maintenance and cleaning
CAUTION
Risk of injury from unintentional starting of
the sweeping machine.
When carrying out maintenance and cleaning
the sweeping machine there is a danger of
items being pulled into the machine due to
the unintentional starting of the sweeping
machine.
•
The device should be switched off and
disconnected from mains supply during all
such work.
•
Never do any work on the machine while the
engine is running.
•
The on/off switch must be in the 0 position.
• Ensure that the device is not switched on by
accident while maintenance and cleaning
work is being carried out. If necessary,
disconnect the blue battery lead. See
Section “Disconnect battery leads” in
Chapter 10.2 of this operating manual.
NOTE
Improper maintenance can lead to damage
or a shortening of the life of the sweeping
machine.
In the following sections the maintenance and
cleaning work required for optimal and fault-free
operation is described.
The conduct of the specified work depends in
some cases on time and/or charge. For the
maintenance interval information shown both in
deadlines and service hours, the one that occurs
first applies.
In case of questions on the maintenance work
and intervals contact the manufacturer.
