Installation of the Infrared Kit
The Infrared Kit accessory allows
POLE STAR
to identify the finish line and
therefore to calculate the lap time.
The Infrared Kit consists of a Transmitter which must be positioned in the pits
(normally on the wall) directed as perpendicularly as possible towards the path of
the motorbike along the straight, and of a sensor (IR Receiver) which must be
fixed onto the vehicle so that the small infrared sensor is directed towards the
Transmitter when passing along the straight. The IR Receiver must be positioned
so that visibility towards the Transmitter is not obscured by any part of the
motorbike or the driver.
Connect the IR Receiver to the connector, of the same colour and type, positioned
on the
POLE STAR
harness.
Turning on and off the device.
To turn
POLESTAR
ON press the PoleSTAR key on the keypad; to turn it OFF
keep the same key pressed for 2 seconds.
Coding the infrared receiver
To prevent interference between various different Transmitters, even of other
makes, which would cause detection of incorrect times, each Starlane Transmitter
is fitted with a personal code. Your IR Receiver must therefore be programmed to
recognise its own Transmitter:
1. Position the Transmitter ten metres in front of the IR Receiver mounted on
the vehicle and connected to
POLE STAR
.
2. Supply the Transmitter with power from a PP3 9V and turn the switch ON.
3. Make sure that
POLE STAR
is off.
4. Press the pushbutton on the IR Receiver and keep it pressed.
5. With the pushbutton on the IR Receiver pressed, turn
POLE STAR
on. The
Red LED on the IR Receiver lights up for a few seconds.
6. When the Red LED goes off, the Transmitter code has been stored in the IR
Receiver.
Page 6
Содержание POLE STAR PRO
Страница 24: ......
