STARLANE POLE STAR PRO, Инструкция по установке и эксплуатации

Страница: 5 / 24

Attention! Never connect the RPM reading wire directly to the coil connector or
any other wire from the harness to prevent any inadequate voltage irreparably
damaging the instrument.
Mounting the speed sensor (optional)
The speed sensor detects the bolts of the brake disk passing in front of its
sensitive point. On the basis of the number of impulses and the wheel
circumference entered,
POLE STAR
calculates the speed.
Carry out the following installation stages:
1. Remove the 2 front wheel pin holding bolts at the base of the right shank of
the fork*.
2. Screw up and lock the bolts supplied.
3. On the threaded extending part, insert the support provided for the sensor
and fix it using the nuts supplied. (the support will bend slightly until it fits the
rounded shape of the fork).
4. Insert the sensor in the appropriate hole on the support and position it so
that the brake disk bolts run at a distance of about 1 mm. from the head of
the sensor.
5. Lock the sensor nuts so as to fix it to the support . Attention! Do not tighten
the nuts too much to prevent “ironing out” the sensor and damaging it
irreparably.
6. Fix the cable to the fork with the special clamps so that it is never under
tension during use.
7. Insert the connector in its counterpart, of same colour and type, positioned
on the
POLE STAR
harness.
8. Switch on
POLE STAR
.
9. Check that the sensor works: every time a bolt passes in front of the
sensor, the yellow LED near the sensor cable output must turn on. If this
does not happen, bring the sensor slightly closer to the head of the bolt (the
bolts must be made of ferrous material), in case of hexagon socket screws
position the sensor with a little offset to avoid the sensor LED lighting up
twice for the hole in the screw head (see picture).
*If the fork has not the mentioned bolts create a proper support and proceed from
point 4.
Pag. 4