BeiJing Starfire Control Technology Co.,Ltd
WeChat:18901200180
QQ: 1908817881
15
[F1] select starting point: press this key continuously to select the starting point of cutting gun positioning, and the
sequence is the bottom left corner the upper left corner the upper right corner the lower right corner the center
point.
[F2] scale: set the scale of processed parts. Example: reduce by half, set 0.5; enlarge by twice, set 2.0.
[F3] layout: arrange the processed parts in a matrix. Note that if staggered arrangement is selected, the even rows are
one less than the odd rows.
[F4] graphics rotation: sets the rotation Angle of the graphics.
[F6] code editing: edit the current cutting file.
[F7] graphic restoration: cancel the operations of graph rotation, mirroring, scaling and discharge, and the graph will
be restored to the original state, but the Angle of steel plate correction will not be cleared. If the Angle of steel plate
correction is needed, enter the screen of manual steel plate correction.
[X]X mirror: the figure is mirrored on the X axis.
[Y] Y mirror: the graph is mirrored on the Y-axis.
3.2 preparation for cutting
3.2.1 parameters to be set before processing
