-9-
Wiring
For proper installation and full operability, this light requires a 10.5A ignition
switched power source, connections to the negative terminal of the battery,
and four external switches rated for a minimum 1A
(user supplied)
.
These lights come with a pre-installed 6-conductor harness. In addition, the cable
also contains a bare drain wire and foil shielding.
Green w/Red
White w/Brown
Green w/Yellow
+
-
BLACK
BARE
Ignition Sw12VDC
Red
Steady Burn Warning Lights
Pursuit Lights (Flashing DLP)
Takedown Lights (Steady Burn DLP)
Orange w/Red
Flashing Warning Lights
DLP
Lights
User Supplied Switches
Warning Lights
10 AMP
FUSE
Wire
Function
Bare
Ground
Black
Ground
Red
Power to light
(+12VDC ignition switched – 10.5A)
Orange w/Red
Warning LED Flashing Mode
Green w/Red
Warning LED Steady Burn (and Burst)
White w/Brown
DLP LED Pursuit Mode
Green w/Yellow
DLP LED Takedown Mode (Steady Burn)
Quick Wiring Guide
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load.
Testing the light before this fuse is properly
installed will void the warranty on the light.
