5
INSTALLATION INSTRUCTIONS
UNCRATING AND INSPECTING
Unpack the unit and components from the shipping container. Remove all visible packing
material and those from inside the cooking chamber. If damage is discovered, file a claim
immediately with the carrier that handled the shipment. Do not operate the unit if it was
damaged during shipping.
ASSEMBLY AND INSTALLATION
The unit was shipped fully assembled and ready to plug into a standard outlet specified for
its voltage and amp draw. If improper electrical supply is determined, contact a qualified
electrician prior to using the unit. Removal and replacement of the power cord and plug will
void the warranty. For assistance, contact your local authorized service agent for service or
required maintenance.
Place unit on a level surface.
This broiler can be very hot during operation. Use care when carving the mead during use.
Allow enough space around the unit for adequate ventilation. Read all labels on the unit and
follow their instructions.
VENTILATION & CLEARANCES
Local codes prevail. These are the “authority having jurisdiction” as stated by the National Fire
Protection Association, Inc. in NFPA 96-Latest Edition. For further ventilation information see
below.
A ventilation hood should be used to remove heat and cooking odors. The hood and HVAC
installation must meet local codes to gain approval by the authority having jurisdiction.
Requirements may vary throughout the country depending on the location by city, county, and
state. Obtain information from the authority having jurisdiction to determine the requirements
for your installation. Obtain information and review copies of codes or documents that will
be used to inspect and approve your installation. Your ventilation hood supplier and HVAC
contractor should be contacted to provide guidance.
ELECTRIC MODEL
The broilers are equipped for the voltage indicated on the nameplate mounted on the unit.
They will operate on alternating current (AC) only. Before making any electrical connection to
this unit, check that the power supply is adequate for the voltage, amperage and requirements
stated on the nameplate.
Disconnect the unit from the power source before installing or removing any parts.
Be absolutely sure that the ground connection for the receptacle is properly wired. Do not
connect equipment to power without proper ground connections. Improper grounding may
result in personal injury or fatality.
Before making any electrical connection be sure to read the data plate located on
the unit.
CONNECT/PLUG UNIT INTO DEDICATED A.C. LINE ONLY SPECIFIED ON THE DATA
PLATE OF THE UNIT.
WARNING
WARNING
CLEARANCES
Combustible
Construction
Non-Combustible
Construction
Floor
0”
0”
Sides
12”
Back
3”
