2M-Z21001 Rev A Owner's Manual fo
r IR
CS4 Impingement/Radiant Split-Belt Conveyor T
oaste
r
5
OTHER TOASTER FUNCTIONS
COOLDOWN
MODE
COOLDOWN
mode can be activated by holding the “DARKER/
LIGHTER” button and the both
▼
buttons for a few seconds.
COOLDOWN
mode takes fifteen [15] minutes to complete,
and causes the heaters to be turned off, but the conveyors,
display, and fan to continue functioning. This mode can be
used for cleaning or simply cooling off the unit.
STANDBY
MODE
STANDBY
mode can be activated by holding the “DARKER/
LIGHTER” button and the right
▲
button for a few seconds.
STANDBY
mode causes the unit to reduce the power supplied
to the heaters to 50% allowing power to be conserved during
slow periods. Toasting can still be accomplished in this mode,
but will take longer.
CLEANING
SUGGESTED CLEANING SUPPLIES
i.
Kay® QSR oven cleaner (degreaser)
ii.
Kay® surface sanitizer
iii.
Mild dish detergent and water
iv.
Clean cloth rag
v.
Non-scratch scour pad
CLEANING PROCEDURE
Preventive maintenance for your toaster consists of the following recommended cleaning
procedures. To keep your toaster in its best operating condition, these steps should be
performed on a daily, or weekly, basis as required.
i.
Turn toaster off (fans will continue to run approx. 10–15
minutes until cooled). You can also activate
COOLDOWN
mode by pressing and holding the “DARKER/LIGHTER”
button and the left and right down buttons. This causes
the toaster to turn off the heating elements but keep
power to all other parts and the display.
ii.
Immediately spray the oven cleaner onto the non-scratch
pad and scrub the conveyor chain while it is still warm
and moving. DO NOT SPRAY DIRECTLY ONTO THE
CONVEYOR BELT OR INTO THE COOKING CHAMBER.
OVERSPRAY ONTO THE HEATING ELEMENTS CAN
DAMAGE OR SHORTEN THE LIFE OF THE ELEMENTS.
iii.
Wash the non-scratch pad then soak with mild dish
detergent. Ring the pad out so that it is only damp and
continue to scrub the conveyor belt while it is still moving.
iv.
Rinse the non-scratch pad to remove all detergent and
then soak with clean, warm water. Ring the pad out so
that it is only damp, and continue to scrub the conveyor
belt while it is still moving.
v.
Wipe the conveyor belt with a clean cloth dampened
with sanitizer solution while it is still moving. Allow
to air dry.
vi.
Rinse the non-scratch pad and then soak with clean
warm water. Ring the pad out so that it is only damp,
and wipe exterior areas of the toaster.
vii.
Wash with mild dish detergent, rinse, and sanitize
removable pieces, and allow to dry before sliding
the trays back into the unit.
viii.
Once dry, the unit is ready for use.
DO NOT IMMERSE THE UNIT IN WATER
OR LET THE UNIT STAND IN WATER.
DO NOT USE A NON-STICK SPRAY ON THE
CONVEYOR BELT, IT WILL CAUSE A STICKY
BUILD-UP AND INCREASE STICKING.
DO NOT HOSE DOWN THE UNIT OR THE
TABLE/COUNTER IF THE UNIT IS ON THE
TABLE/COUNTER.
COOLDOWN
14 : 55
STANDBY
