Star CAPELLA CP-2, Руководство пользователя

Страница: 78 / 82

page
78
page
79
Periodic Service Schedule
Read all of SAFETY and this section before attempting any procedure.
Pay particular attention to Notices, Cautions, Warnings and Dangers
ANALYSIS AND ELIMINATION OF COMMON FAULTS
Fault phenomenon Possible causes Solution
Operator error See Operational Guidelines for Correct
Operation
Terminal oxidation (corrosion) Turn off the power supply, remove the
nuts, clean the terminals and install
Batteries are under-charged Charge
Direction switch damage Replace
Accelerator damage Replace
Motor damage Replace
Damage of directional contactor Replace
Wire harness socket loose Recover or Replace
Vehicles travel slowly until
they stop while climbing
the slope. Whether the vehicle is overloaded,
resulting in the controller tempera-
ture higher than 75 degrees Celsius
and shutdown protection Reduce vehicle load and let the control-
ler cool down
When a vehicle is running,
release the acceleration
pedal, and the vehicle will
not slow down. Accelerated pedal spring rupture,
resulting in pedal cannot be restored Turn off the lock or press the emergency
power off button then contact the
manufacturer.
Open the electric lock, the
auxiliary electrical equip-
ment of the whole car does
not work. Fuse burnout or poor electrical
contact Replace fuse repair relay
Loose plug-in of alarm circuit Locking plug-in
Fuse burnt out Replace fuse
Tire pressure imbalance Inflation to balance tire pressure
Front and rear wheels uncorrected Correction wheel
Insufficient tire pressure Inflate
The steering linkage shaft lacks
lubrication Add lube oil
Damage of steering pin or ball joint Replace
Ball joint damage Replace
Under-commissioning or wear of
steering gear Debugging or replace
Relaxation of steering linkage axle Fastening