26
STAR TRAC P-ST STEPPER O
WNER
’
S
M
ANUAL
P
REVENTATIVE
M
AINTENANCE
With durable, high performance components, the
STAR TRAC P-ST STEPPER
is designed for heavy usage with minimal maintenance
required. To keep your Stepper in top condition, Star Trac strongly recommends performing the regular daily, weekly and monthly preven-
tive maintenance routines outlined below. Any unusual symptoms, such as a loud continuous noise during operation, should be reported to
STAR TRAC PRODUCT SUPPORT DEPARTMENT
at (800) 503-1221, or USA 1-714-669-1660.
DAILY MAINTENANCE
I
Remove excessive accumulations of dust, dirt, and other substances by using a clean, soft cloth and a non-abrasive liquid cleaner, such
as Formula 409
TM
or FANTASTIK
TM
. Wipe down the exterior of the display panel, hand rails, pedals, shrouds and heart rate grips.
NOTE:
DO NOT spray the cleaner directly onto the Display Panel or heart rate grips.
WEEKLY MAINTENANCE
Perform the following services each week:
I
Vacuum the floor under and around the Stepper. Move the Stepper to another spot, if necessary, to vacuum thoroughly.
I
Inspect the Display Panel mounting screws for security, and retighten if necessary.
I
Inspect the Display Panel keypads for wear.
MONTHLY MAINTENANCE
Perform the following services each month, or as needed:
I
Check that the pedals and shrouds are secure.
I
Check the hand rails for looseness. Tighten screws as necessary.
I
Check for smooth and quiet operation of all moving parts.
M
ANAGER
/ M
AINTENANCE
M
ODE
After using your
STAR TRAC P-ST STEPPER
for a period of time, you may wish to change some of its settings.
MANAGER MODE
The Manager Mode lets you query and modify the basic settings of your Stepper. To enter Manager Mode:
1. Press and
hold
the
,
and keys
together.
2. A beep will sound and “MANAGER MODE” will display momentarily in the Information Window.
3. Release all keys. “SERIAL NO #####” will display in the Information Window.
NOTE:
The system will automatically exit Manager Mode if no key is pressed for 30 seconds.
The following keys are used to modify settings in MANAGER MODE:
Upper and Lower Data Information Window S
CROLL
Keys:
Display the next and previous parameters, respec-
tively.
Increase and Decrease L
EVEL
Keys:
Adjust the value of the displayed parameter up and down, respectively, in incre-
ments of 1 unit. These keys
do not
save the new value - see
OK Key
below.
Numeric Keypad:
Allows you to enter specific values for numeric parameters. These keys
do not
save the new value
- see
OK Key
below.
