BEFORE PROCEEDING WITH BULB REPLACEMENT, OPERATORS MUST:
1. FULLY DISCONNECT THE DEVICE FROM POWER SUPPLY AND MAKE SURE THE BULB IS COLD
2. NOT TOUCH THE BULB WITH THEIR BARE HANDS.
REPLACEMENT OF BULB
2. SVITARE LE 4 VITI DEL RETRO
1. HELIOSA HI DESIGN 33
3. TOGLIERE LE DUE COPERTURE LATERALI E LE DUE
TESTATE DELLA PARABOLA
1
2
3
14
1. HELIOSA 88
2. PER SOSTITUIRE IL BULBO, ESERCITARE UNA LEGGERA PRESSIONE
VERSO DESTRA (LIBERANDO COSI' LA PARTE SINISTRA) E POI VERSO
SINISTRA.
3. TO FIT THE NEW BULB PROCEED IN THE REVERSE ORDER, MAKING SURE THAT
THE BULB ENDS CORRESPOND WITH THE BULB HOLDER CONTACTS.
2. TO REPLACE THE BULB, PRESS GENTLY TOWARD THE RIGHT (THIS
RELEASES THE LEFT SIDE). THEN PRESS TOWARD THE LEFT
REMOTE CONTROLLER – USE
START-UP
The functions of the remote control provided are as follows:
-turn on
-half-power control
-turn off
TO TURN ON:
point remote control at sensor of appliance, press POWER 100% button for 1 or 2 seconds. A green indicator will immediately
light up (confirming electrical start up). The full power regimen of the appliance is reached in approx. 30 seconds.
HALF-POWER CONTROL
for half-power, press POWER 50%
TO TURN OFF:
press OFF button
