Star Max 530FF SERIES, Инструкция по установке и эксплуатации

Страница: 4 / 12

OPERATING INSTRUCTIONS
PLACE THE LAMINATED WARNING SIGN SUPPLIED WITH THE FRYER IN AN
AREA VISIBLE TO THE FRYER OPERATOR.
CLEAN KETTLE BEFORE USING
Take out baskets, push and hold element catch, lift up on element lift handle until elements lock in a
vertical position, and remove kettle. The kettle can be cleaned in a sink like any other pot or container.
ADDING FAT
Replace kettle and swing the element down, making fryer ready for use. Add fat. A fat level line on the
rear of the kettle will guide you in determining the minimum cold fat level. A higher fat level can be used
when frying bulky foods, such as chicken or fish cakes. The fat level should be chosen carefully so that
the foaming action of the fat does not spill out of the kettle. If solid shortening is used, pack carefully
around the elements.
CONTROLS
1. ON/OFF TWO-POLE SWITCH - Located on the front panel is a two-pole switch which turns power on
or off. An indicator light (Power On) is located on the control housing.
2. THERMOSTAT CONTROL - Located on the Control Housing, this control allows you to select the
desired frying temperature. A signal light "Heating" indicates when the element is on. When the light
goes off, the desired temperature has been reached.
3. HI-LIMIT THERMOSTAT - Should fat temperatures reach 450°F (230°C), this control will shut off the
power. Both lights on the control panel will go out. The fat temperature must cool to 400°F (202.4°C)
and the manual reset button located on the back panel of the control housing must be pressed to
restore operation. Should the
hi-limit control activate twice in succession, the primary thermostat should be checked for malfunction
by a qualified service technician.
FRYING
After fat has been added, turn the switch on and set the thermostat at 200° F (92.4° C). After the fat has
melted, turn the thermostat to the desired setting. Included in this instruction booklet is a frying chart and
some helpful hints on fat use. After the selected fat temperature has been reached, slowly lower half filled
baskets into the fat. Do not overload baskets as this causes foods to be improperly fried.
NOTE: Baskets should be allowed to drain after frying cycle. The kettle handles
serve as basket hangers.
IDLING
During idle periods turn thermostat control to approximately 200°F (92.4°C). The fast recovery fryers can
be brought up to frying temperature in a matter of minutes. Lowering the temperature during idle periods
saves energy costs and prolongs fat life.
INAPPROPRIATE USE DUE TO A LACK OF COMMON SENSE MAY RESULT IN
PRODUCT DAMAGE OR PERSONAL INJURY.