Star Headlight & Lantern ULB34, Быстрый старт

Страница: 5 / 8

-4-
Pattern List
1. Slow Warn
2. Fast Warn
3. Superfast Warn
4. Warn Fade*
5. Pre-Pop Warn
6. All Singleflash
7. Alt. Tripleflash
8. All Tripleflash
9.
Alt. Quadflash w/Post Pop
10. All Quadflash w/Post Pop
11. Alt. Quintflash
12. All Quintflash
13. Alt. Pre-Pop Quintflash
14. All Flicker
15. Alt. PSU Flicker
16.
One Side Pop, Other Rapid Fire
17.
One Side Rapid Fire, Other Pop
18. Comet 1*
19. Comet 2*
20. Delta Omega (Flash Rate Sweep)
21. Slow Warn, Alt. Tripleflash
22. Slow Warn, Super Fast Warn
23. All Doubleflash, Alt. Doubleflash
24. All Doubleflash, Alt. Doubleflash, Flicker
25. Alt. Doubleflash, Flicker
26. All Double, Alt. Pre-Pop Tripleflash, Slow Warn
27. Alt. Doubleflash Non-Synch
28. Alt. Tripleflash, Alt. Pre-Pop-Triple, Flicker
†
29. Alt. Quadflash, Flicker, Alt. Doubleflash, Flicker
30. Alt. Pre-Pop Quintflash, Alt. Quintflash, Flicker
31. One Side Steady-----One Side Singleflash
32. One Side Steady-----Other Side Short-Long
33. Medium Warn (Alternating Long Singleflash)
34. Alternating Short - Alternating Long
35. Demo Mode – Loop All Patterns
†
Default Pattern
*
These patterns do not dim under low power
PLEASE NOTE : The green wire is only used for programming purposes during installation.
1. Connect the black wire to Ground.
2. Activate the light by applying power (+12VDC) to the red wire.
3. Briefly touch and release the green wire to ground to scroll through the patterns listed
below. The cycle will repeat itself after the last pattern.
4. Once you find the pattern you wish to select, leave the green wire disconnected and
turn the unit off. This will program that pattern into the memory. Tape the end of the
green wire so that it does not come into contact with ground accidentally.
NOTE: If at any time you would like to reset the pattern to the factory default, simply touch
the green wire to ground for six seconds until the light blinks twice.
Pattern Programming