Star Headlight & Lantern ULB34, Быстрый старт

Страница: 4 / 8

-3-
The ULB34 is powered through the 4-wire harness that comes pre installed on the light. Connect
the four wires as follows:
Black - ( Ground) Connect to a good chassis ground
Red - ( Power/+12 VDC) Connect to your On/Off switch (not supplied) through a 5 amp
fuse (not supplied) .
Green - (Pattern Select) Touch to a ground to change patterns
(see Pattern Programming section on next page)
White - (High/Low) Controls the intensity of the light
Low Only: Connect the white wire to a good chassis ground if you wish to
run the light on low power.
High Only: Tape the end of the white wire off so that it does not come into
contact with ground, if you wish to operate the light on high
power.
Switched: Connect the white wire through a switch to ground if you would
like to have the ability to switch between high and low power.
All standard Phantom lights are designed for 12VDC negative ground vehicles only.
Reverse polarity may cause serious damage to the lightbar and/or vehicle. Contact
the automotive dealer if there are any doubts about the polarity of your vehicle.
Wiring Instructions
GOOD
CHASSIS
GROUND
Ground = Low
Open = High
WHITE
5 AMP
FUSE
T
o
u
c
h
a
n
d
re
le
a
s
e
to
g
ro
u
n
d
to
c
h
a
n
g
e
p
a
tte
rn
s
B
L
A
C
K
G
R
E
E
N
RED
HIGH/LOW
SWITCH
(Optional)
CONNECT
TO +12 VDC
4-Conductor Cable
From ULB34