-3-
1. Snap one pivot bracket onto each side of the light.
1. Align the notch in the label with the center of the
hood taking care that the front edge of the label lines
up with the front edge of the hood.
Practice installing label BEFORE removing backing.
2. Hold one half of the label
firmly in place with the
backing still affixed.
Because it takes about 72 hours or 3 days for the adhesive to reach full
bonding potential, check the light often during this period to ensure the
tape maintains full contact with the bracket and glass.
3. Slowly start to peel the backing off of the other
half of the label from the center out.
5. Using your finger or other cylindrical object, carefully "roll" the
label through the corner ensuring that no air bubbles form. If your
hood has bolt heads inside, smooth the label or cut it as needed.
6. Repeat the process to affix the other half of the label to the hood.
4. Gradually peel the backing off of the rest of
that half of the label carefully rolling it into
place along the hood.
2. Hold one half of the label
firmly in place with the
backing still affixed.
2. Select a location for your light and hold the light up to the
window adjusting the pivots such that the light is approximately
level.
DO NOT MOUNT ON DEFROSTER LINES!!
3.
Thoroughly
clean your windshield with alcohol and ensure it is dry.
4. Remove the backing from the double sticky tape on the
light and place the light in the chosen location pressing
VERY LIGHTLY on just the brackets. Check the light from
the front and back to verify placement. If placed correctly,
press firmly on the brackets ensuring maximum contact and adhesion.
Note - if a placement mistake is made, quickly remove light by levering
off the brackets with a flat blade screwdriver.
Optional Reflective Hood Label Installation
(ULB9S Mounting CONT’D)
Flush Window Adhesive Mount
