-5-
Advanced Programming
This section is OPTIONAL. Most applications will not require any
Advanced Programming. You should only need to reference
this section if you require specialized programming.
STOP !!
Advanced Programming Options
•
Alternate Default Wire Setups
•
Custom Wire Programming / Priority Modification
Includes Work Lights (bright steady burn), Cruise Mode (dim steady
burn), and Single Head Steady Burn (California Title 13)
•
Head Enable (which heads activate)
•
Phase Selection (which heads alternate from one another)
Alternate Default Wire Setups
The default wire setup is shown on page 2 (Wiring Setup 2). For ease of
programming, this light has been designed with three additional default setups.
Follow the instructions below to reprogram the wires for Setup 2, 3, or 4.
1. Connect the RED wire to GROUND and the
BLACK wire to GROUND.
2. Hold the Pattern Select wire (RED w/GREEN) to
+12VDC
then release it after the time indicated in
the chart to the right.
Wiring Function Setup
Hold
#
Wiring
Patt. Sel. Flashes Setup #
3 sec
1
Setup 1
6 sec
2
Setup 2
Wiring Setup 2
ORANGE w/RED
- Flashing Arrow Tips
(Color 1 and 2 - PATTERN 8)
RED w/GREEN
- Pattern Select
BLACK
- Ground
YELLOW
- Steady Arrow Tips
(Color 2)
PINK
- Cruise
(Color 1)
RED
- Power
WHITE w/BROWN
- Left Arrow
(Color 1 - TD PATTERN STYLE 8)
GREEN w/YELLOW
– Right Arrow
(Color 1 - TD PATTERN STYLE 8 )
-6-
(Advanced Programming CONT’D)
Hold
Red wGreen
#
to +12VDC
Flashes Programming Description
1 sec
0
Increments Pattern
(see pages 3-4)
3 sec
1
Shortcut to Pattern 1
(see pages 3-4)
6 sec
2
Shortcut to Pattern 22
(see pages 3-4)
9 sec
3
Custom Wire Programming Mode
Touch and release
Red w/Green
to
Ground
to
advance to desired options
(see page 8)
12 sec
4
Color 1 Head Enable Programming Mode
Touch and release
Red w/Green
to
Ground
to
scroll through Head Enable options
(see page 9)
15 sec
5
Color 2 Head Enable Programming Mode
Touch and release
Red w/Green
to
Ground
to
scroll through Head Enable options
(see page 9)
18 sec
6
Phase Programming Mode
(see page 9)
Touch and release
Red w/Green
to
Ground
to
scroll through Phase options
(see page 10)
21 sec
7
Toggles between Flashing Mode and Work Lights
Programming Summary Chart
The chart below gives a quick overview of many of the programming options.
Pattern Incrementing and the Pattern 1 shortcut are discussed earlier in this manual.
The additional modes are described in further detail on the following pages.
1. Connect the RED wire to GROUND and the BLACK wire to GROUND.
2. Connect the function wire that you want to reprogram to +12VDC.
3. Select the option you wish to program and review the corresponding pages.
4. Save your programming by holding the Pattern Select wire to
+12VDC
until the unit
flashes once (~3 seconds), then releasing it.
