Stanley STDC12, Оригинальное руководство пользователя

Страница: 10 / 14

10
ENGLISH
(Original instructions)
- If the clutch ratchets before the desired
result is achieved, increase the collar
setting and continue tightening the screw.
Repeat until you reach the correct setting.
Use this setting for the remaining screws.
Drilling in masonry (fig. H & I)
• For drilling in masonry, set the collar (3) to the hammer
drilling position by aligning the symbol with the
marking (16).
• Slide the speed selector (5) towards the front of the tool
(2nd gear).
Speed selector (fig. I)
• For drilling in steel and for screwdriving applications,
slide the speed selector (5) towards the rear of the tool
(1st gear).
• For drilling in materials other than steel, slide the speed
selector (5) towards the front of the tool (2nd gear).
Drilling/screwdriving
• Select forward or reverse rotation using the
forward/reverse slider (2).
• To switch the tool on, press the switch (1). The tool
speed depends on how far you press the switch.
• To switch the tool off, release the switch.
Hints for optimum use
Drilling
• Always apply a light pressure in a straight line with the
drill bit.
• Just before the drill tip breaks through the other side of
the workpiece, decrease pressure on the tool.
• Use a block of wood to back up workpieces that may
splinter.
• Use spade bits when drilling large diameter holes in
wood.
• Use HSS drill bits when drilling in metal.
• Use masonry bits when drilling in soft masonry.
• Use a lubricant when drilling metals other than cast iron
and brass.
• Make an indentation using a centre punch at the centre of
the hole to be drilled in order to improve accuracy.
Screwdriving
• Always use the correct type and size of screwdriver bit.
• If screws are difficult to tighten, try applying a small
amount of washing liquid or soap as a lubricant.
• Always hold the tool and screwdriver bit in a straight line
with the screw.
Accessories
The performance of your tool depends on the accessory
used. Black & Decker accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your too
Maintenance
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
• Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
• Regularly open the chuck and tap it to remove any dust
from the interior.