Stanley SPT-182-570, Оригинальное руководство пользователя

Страница: 7 / 233

7
any other liquid. Keep handles dry, clean and
free from debris. Clean after each use.
Observe proper disposal laws and regulations
for gas, oil, etc. to protect the environment.
Store idle machine out of the reach of children
and do not allow persons unfamiliar with
the machine or these instructions to operate
it. Machine is dangerous in the hands of
untrained users.
Service
Before cleaning, repair, inspecting, or adjusting
shut off the engine and make certain all
moving parts have stopped. Always make
sure the engine’s throttle control is in its STOP
position. Disconnect the spark plug wire, and
keep the wire away from the plug to prevent
accidental starting.
Have your machine serviced by qualified repair
personnel using only identical replacement
parts. This will ensure that the safety of the
machine maintained.
Specific Safety Rules
Do not operate without wearing adequate
winter outer garments.
Do not use the machine on a roof.
Do not run the engine indoors, except when
starting the engine and for transporting
the snow thrower in or out of the building.
Open the outside doors; exhaust fumes are
dangerous.
Always check overhead and side clearances
carefully before operation. Always be aware of
traffic when operating along streets or curbs.
Thoroughly inspect the area to be worked.
Keep the working area clean and free of toys,
doormats, newspapers, sleds, boards, wires
and other foreign objects, which could be
tripped over or thrown by the auger/impeller.
Check for weak spots on docks, ramps or
floors.
Plan your snow-throwing pattern to avoid
discharge toward people or areas where
property damage can occur.
Do not operate near drop-offs, ditches, or
embankments. Machine can suddenly turn
over if a wheel is over the edge of a cliff or
ditch, or if an edge caves in.
Keep all bystanders, children, and pets at least
23m (75 feet) away. If you are approached,
stop the unit immediately.
Use a grounded three-wire extension cord and
receptacle for all machines with electric start
engines.
Check clutch and brake operation frequently.
Adjust and service as required. All motion of
drive wheels and auger/impeller must stop
quickly when control levers are released.
Let engine and machine adjust to outdoor
temperature before starting to clear snow.
Stay alert for hidden hazards or traffic.
Do not overload machine capacity by
attempting to clear snow at too fast of a rate.
Do not throw snow any higher than necessary.
Adjust auger housing height to clear gravel
or crushed rock surfaces. Exercise extreme
caution when operating.
Exercise caution to avoid slipping or falling,
especially when operating in reverse. Never
operate machine at high transport speeds
on slippery surfaces. Always look down and
behind before and while backing.
Do not operate on steep slopes. Do not
G
B