Stanley SBI201, Оригинальное руководство пользователя

Страница: 6 / 20

6
ENGLISH (
Original Instructions)
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
• If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised STANLEY Service
Centre in order to avoid a hazard.
ADDITIONAL SAFETY INSTRUCTIONS FOR
BATTERIES AND CHARGERS
Batteries
• Never attempt to open for any reason.
• Do not expose the battery to water.
• Do not store in locations where the temperature may
exceed 40 °C.
• Charge only at ambient temperatures between 10 °C
and 40 °C.
• Charge only using the charger provided with the tool.
• When disposing of batteries, follow the instructions
given in the section “Protecting the environment”.
Do not attempt to charge damaged batterie
Chargers
• Use your STANLEY charger only to charge the battery
in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
• Never attempt to charge non-rechargeable batteries.
• Have defective cords replaced immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use
LABELS ON TOOL
The following symbols are shown on the tool along with the
date code:
WARNING ! To reduce the risk of injury, the user
must read the instruction manual.
Always wear safety goggles
Always wear safety hearing protection
Do not stare at operating lamp.
Position of date code
The Date Code, which also includes the year of manufacture,
tis printed into the housing.
Example:
2017 XX JN
Year of manufacturing
PACKAGE CONTAINS
The package contains:
1 Impact driver
1 Charger
2 Batteries (C2/S2/D2) or 1 Battery (C1/S1/D1)
1 Belt clip
1 Instruction manual
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (FIG. A)
This appliance includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Bit holder
4. Bit holder collar
5. Battery
6. Belt clip
7. LED work light
8. Magnetic bit holder
9. State of charge indicator
10. Battery release button
Fig B
11. Charger
12. Charging indicator
Assembly
WARNING ! Before assembly, remove the battery
from the tool.
CHARGING THE BATTERY
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before. The battery may become warm
while charging; this is normal and does not indicate a
problem.
WARNING ! Do not charge the battery at ambient
temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
NOTE : The charger will not charge a battery if the cell
tempera ture is below approximately 10 °C or above 40
°C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell temperature
warms up or cools down.
• Plug the charger into an appropriate outlet before
inserting the battery pack.
• Insert the battery pack into the charger.
The green LED will flash indicating that the
battery is being charged.
The completion of charge is indicated by the
green LED remaining on continuously.
The pack is fully charged and may be used
at this time or left in the charger.
WARNING ! Recharge discharged batteries as
soon as possible after use or battery life may be
greatly diminished.