Stanley RD60, Руководство оператора

Страница: 31 / 40

Problem Possible Cause Possible Solution
BATTERY PACK IS NOT
CHARGING PROPERLY
No power to charger Check operation of receptacle by plugging in
a lamp or other appliance.
Check to see if receptacle is connected to a
light switch which turns power off when you
turn out the lights.
Temperature is outside the
operating range of the charger
Move the charger and battery pack to
a location where the surrounding air
temperature is approximately 60°F - 75°F (18°
- 27° C).
Other issue Take the tool, battery and charger to an
authorized D
E
WALT service center.
TOOL WILL NOT DRILL
THROUGH RAIL OR
DOES NOT PERFORM
AS WELL AS IT ONCE
DID
Low battery charge Stop the drill and retract the bit. Remove and
charge the battery.
No Coolant to the bit Ensure the coolant canister is full and
pressurized. Fill if necessary.
Tool Failure Take the tool, battery and charger to an
authorized D
E
WALT service center.
TOOL WILL NOT
RETRACT FROM THE
RAIL OR DOES NOT
DRILL THROUGH A RAIL
Improperly adjusted / loose rail
clamp
Ensure the rail clamp is tight around the rail
and that the rail clamp adjustment knob is
tight.
62211 | February 2022 | 31
Troubleshooting