Installation Instructions for Stanley Omnilock 45HOM Mortise Locks
Stanley Omnilock
a Product Group of Stanley Security Solutions, Inc.
3
Installation Instructions for Stanley Omnilock 45HOM Mortise Locks
Planning the installation
1 Separate the templates provided on the
OM1
Template — Installation Template for 45H Mortise
Locks (T83316)
.
Note:
If installing an Extreme Weatherized model,
see Installation Addendum for Stanley Omnilock
45HOM Extreme Weatherized Locks (T83317). This
includes the template for locating the extreme
weatherized module mounting holes.
2 Position one of the door edge templates on the
door, making sure that the lock case mortise
shown on the template aligns with the mortise
pocket prepared in the door.
3 Using the centerlines on the door edge templates
as guides, position the appropriate door template
on each side of the door. You need to take the
bevel into account. Tape the templates to the
door.
3
Center punch and drill holes
1 Center punch the necessary drill points. See the
instructions on the template.
2 Drill the holes.
Note 1:
To locate the center of a hole on the
opposite side of the door, drill a pilot hole
completely through the door.
Note 2:
For holes through the door, it is best to drill
halfway from each side of the door to prevent the
door from splintering.
4
Optional: Install door status switch
(Optional for TV function wireless
locks only)
1 Locate the centerpoint for the door status switch
2 1/2” (64mm) above the top of the faceplate
mortise on the edge of the door as shown in
Figure 4.
2 Drill a 1” (25 mm) diameter hole 1 3/4” (44 mm)
deep for the door status switch.
3 Position the drill so the tip of the bit is
approximately 1”(25 mm) into the hole and the
Outside
Outside
Left hand (LH)
Right hand (RH)
Left hand
reverse bevel
(LHRB)
Right hand
reverse bevel
(RHRB)
Figure 3
Door Handing Chart
Figure 4
Installing the door status switch
Door status
switch
Shield
Optional for Wireless TV Models
Door status
switch sensor
Centerline
Door
Door Jamb
