OPERATION INSTRUCTIONS
WARNING:
Do not operate the stove with the
appliance door open, or if the glass panel in the
front door has been broken or removed. Ensure
that the door latch is fully locked. Keep the door
spin valve closed at all times when stove is in
operation.
PRECAUTIONS
1.
Do not touch any part of the stove while in
operation, except the controls.
2.
Children and adults should be alerted to
the hazards of surface temperatures.
3.
Guards may be required to take account of
the special hazards that exist in nurseries
and other places where there are young
children, aged or infirm persons.
4.
Curtains or other combustible material
should not be positioned on/or above the
appliance at a distance less than 38”
(965mm).
5.
Do not use this appliance if any part has
been under water, immediately call a qual-
ified service technician to inspect the appli-
ance and to replace any part of the gas
control or system which has been under
water.
6.
Do not store gasoline or other flammable
liquids having flammable vapours near this
stove.
7.
Tools must not be used to turn or operate
the valve control knob.
8.
Use only in a sufficiently ventilated space.
9.
This appliance must be installed in accor-
dance with the rules in force.
10.
Read the label and manual provided
before commencing to install or attempting
to operate the stove.
Failure to do so may result in property
damage or personal injury.
LIGHTING
1.
The stove control knob is located at the
bottom right hand side looking from the
front.
2.
The valve is in the off position when the
control knob symbol “OFF” is at the datum
point and there is no gas to the pilot or
main burner. The knob can only be turned
in a clockwise direction to reach the “OFF”
position. (see fig.1)
Fig. 1
3.
Press the control knob all the way in and
turn anti-clockwise until you hear a clicking
sound.
4.
Keep the control knob pressed for 15-30
seconds, and then release . If the pilot
fails to remain lighting repeat this action.
5.
With the pilot burner lighting, to establish
the flame hold the control knob in the fully
pressed position with dot pointing towards
ignition. (see fig. 2)
Fig. 2
6.
To light the main burner, fully release
the control knob and turn anti-clock-wise to
the required setting. (see figs. 3&4)
2
High Flame Setting
Fig. 3
