IMPORTANT:
Please ensure that the pilot injec-
tor is clear at all times, as a partially blocked injec-
tor will result in a reduced flame which may be
insufficient for ignition purposes.
MAINTENANCE
CAUTION:
Maintenance of this stove should only
be carried out by a qualified/competent Gas
Engineer.
Isolate the main gas supply before carrying
out any maintenance.
Removal of Burner
1.
Shut off gas supply at the shut off valve.
2.
Open door (item 9).
3.
Carefully remove the coals.
4.
Disconnect the 8mm gas pipe at the back
of the control under the lip. (see Fig.32)
12
Fig.32
5.
Disconnect the snap switch leads from the
snap switch located at the back of the
stove. (See Fig. 33).
6. Under the two M6
wing nuts located on
the under side of the
stove on the right and
on the left. (See Fig.
33).
7. Carefully lift up the
burner assembly start
ing with the left side
and gradually turning
the assembly anti-
clockwise until the left
side of the assembly
is facing towards the
door opening. (See
Fig.35, 36, 37).
Fig.33
Fig.34
Fig.35
Fig.36
Fig.37
Fig.38
Changing of Burner Injector Orifice
With the complete burner assembly removed as
per Fig. 36, 37, 38.
1.
Disconnect the 6mm gas feed pipe from
the control to injector. (see Fig. 39).
2.
Slacken the 6mm gas feed pipe to the
injector at the control.
3.
Remove Injector from burner.
Removal of Pilot Burner
1.
Unscrew the two
1
/4
” slotted head screw
from pilot burner. (See Fig.39)
2.
Disconnect the 6mm gas feed pipe.
Fig.39
