Stanley MA900n, Инструкция по установке и эксплуатации

Страница: 16 / 36

© 2005, The STANLEY WORKS. ALL RIGHTS RESERVED.
203936 Rev. C
MA900 Installation Manual
14
3. Identify the two 1/8” holes made previously on the door for
mounting the track brackets.
4. If the door is made of metal, use a 25/64” bit to drill holes for
the Riv-nuts supplied, or a 3/8” bit to drill holes for the sex nuts
supplied.
5. If the door is made of wood, use a 3/8” bit to drill holes for the
sex nuts supplied.
6. Attach the two track brackets, using the 1/4-20 x 1” flat-head
screws supplied.
7. Assemble the slide block into the door track.
8. Assemble the Allen screws into the slide block so that the
block slides smoothly and has no side-to-side movement.
9. Slide one end of the track onto the track bracket as shown
in Fig. 18.
Fig. 18
Sliding one end of track onto track bracket
Fig. 19
Pressing other end of track onto track bracket
10. Press the other end of the track onto the track bracket as
shown in Fig. 19 and assemble using the two
1/4-20 x 9/16” flat-head screws supplied.
11. Tighten the screws fully.
12. Assemble the pin into the door arm.
13. Assemble the door arm and pin assembly into the slide block in
the door track.
14. Assemble the door arm onto the operator output shaft. Do not
tighten the hex bolt.
15. Assemble the operator arm retainer using the 1/4-20 x 9/16”
flat-head screw supplied.
16. Open the door to the desired position.
17. Tighten the bolt on the door arm.
18. Set the mode switch to the Day position.
19. Power down.
20. Test door operation by manually pushing the door to its fully
open position.
• If the door opens to the desired angle, go to Tune-In
Procedures section of this manual.
• If the door does not open to the desired angle, loosen the
bolt on the operator output arm. Power up, set the mode
switch to Hold Open, and repeat the procedure from
step 16.