Stanley K1700, Инструкция по установке и эксплуатации

Страница: 28 / 50

28
11 Maintenance
The Waterford Stanley boiler model pellet stove requires careful maintenance. The most important thing is to remove the ash from
the pellet burning area at regular intervals. This can be easily done by using a simple household vacuum cleaner. It should be
cleaned after burning approximately
30kg of pellets.
Note:
However, before cleaning, the power of the stove must be turned off and the stove should be cold enough to prevent
accidents from occurring.
11.1 Weekly Maintenance K1200 model.
Remove the burning pot and the ash pan and vacuum both. The interior of the unit must also be cleaned by removing the top
cover plate and cleaning the airflow pipes, as shown in Fig 27
Error! Reference source not found. . Finally, assemble the parts
in the reverse order to which they were removed and close the unit door.
To perform maintenance on the boiler model, clean the airflow pipes. To do this, raise the lid on the top of the unit and then lift
the levers inside several times (Figure 26) to make the dirt accumulated inside the pipes fall out.
a) b)
Figure 26 – Cleaning the turbulators
Then clean the inside of the unit using a steel brush on the surfaces where dirt has accumulated
(Figure 27).
a) b)
Then remove the burn pot (Figure 28-a) and the ash basket (Figure 28-b) and vacuum the ashes from both.
The interior of the unit must also be cleaned by opening the hatch, as shown in figure. Finally, assemble the
parts in the reverse to which they were removed and close the unit door.
a) b)
Figure 28
– a) Burning basket; b) Ash basket
WARNING! The maintenance task frequency depends on the quality of the pellets.