Stanley Fatmax SFMCS300, Оригинальное руководство пользователя

Страница: 9 / 96

9
ENGLISH (Original instructions)
● Adjust the angle of the handle on the tool so you are as
close to the work surface as possible.
Sawing metal
Be aware that sawing metal takes much more time than
sawing wood.
● Use a saw blade suitable for sawing metal. Use a fine-
tooth saw blade for ferrous metals and a coarser saw
blade for non-ferrous metals.
● When cutting thin sheet metal, clamp a piece of scrap
wood to the back surface of the workpiece and cut through
this sandwich.
● Spread a film of oil along the intended line of cut.
Pocket cutting in wood
● Measure and mark the required pocket cut.
● Fit a saw blade suitable for pocket cutting.
● Rest the shoe (3) on the workpiece in such a position that
the blade forms an appropriate angle for the pocket cut.
● Switch on the tool and slowly feed the blade into the
workpiece. Make sure that the shoe (3) remains in contact
with the workpiece at all times.
Cutting branches
Branches up to 25 mm in diameter can be cut with this tool.
@
Warning! Do not use the tool while in a tree, on a
ladder or on any other unstable surface. Be aware of
where the branch will fall.
● Cut downward and away from your body.
● Make the cut close to the main branch or tree body.
Vertical cutting
The tool allows close cutting to corners and other
difficult areas.
● Insert the shank of the saw blade into the blade holder
with the teeth of the blade facing upward.
● Hold the tool with the shoe (3) facing downward so that
you are as close to the work surface as possible.
● Cut forward and away from your body.
Accessories
The performance of your tool depends on the accessory used.
STANLEY FATMAX accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your tool.
Blades
The saw will accept a blade up to 30 cm long. Always use
the shortest blade suitable for your project but long enough
to keep the blade cutting through the material. Longer blades
are more likely to be bent or damaged during use. During
operation some longer blades may vibrate or shake if the saw
is not kept in contact with the workpiece.
Maintenance
Your STANLEY FATMAX tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
@
Warning! Before performing any maintenance on
the tool, remove the battery from the tool. Unplug the
charger before cleaning it.
● Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
● Regularly clean the motor housing using a damp cloth.
● Do not use any abrasive or solvent-based cleaner.
● Regularly open the chuck and tap it to remove any dust
from the interior.
Protecting the environment
Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com