Stanford Research Systems PS355, Руководство по эксплуатации и обслуживанию, Страница: 30 / 42

Stanford Research Systems
PS300 Series High Voltage Power Supplies
Remote Operation 3 – 8
TMOD(?) {
i
}
Trip Mode
The TMOD command sets (queries) the trip reset mode {to i }. The
value
i
= 1 sets manual trip reset, while the value
i
= 1 sets the trip
reset mode to automatic.
Example:
TMOD 1
VLIM(?) {
x
} Voltage Limit
The VLIM command sets (queries) the value of the voltage limit
{to x }, in volts. The sign of value x must match the polarity of the
power supply. As with front-panel control, the VLIM value must be
greater than or equal to the VSET value or an execution error will
be returned.
Example:
VLIM?
-2.0000E4
VSET(?) { x } Voltage Set
The VSET command sets (queries) the value of the voltage se ing
{to
x
}, in volts. If SMOD 1 (rear-panel control) is enabled, then
se ing the VSET command returns an error. The value x must
match the polarity of the power supply.
When SMOD = 0 (front-panel control), the VSET? query returns
the set parameter (not the measured output voltage, see VOUT?
§ 3.4.4 ). When SMOD = 1 (rear-panel control), the VSET? query
returns the high voltage se ing programmed by the rear-panel
HVSET input. As with front-panel control, the VSET value must
be less than or equal to the VLIM value or an execution error will
be returned.
Example:
VSET?
19555
3.4.6 Interface Control Commands
*RST Reset
The
*RST
common command resets the power supply to its default
con fi guration. It is the same as holding the [CLR] bu on
depressed at power on.
Example:
*RST