Standard Horizon HX751, Руководство пользователя

Страница: 28 / 56

HX751 Page 28
To start Preset Priority Channel scan:
1. Press the [
SCAN
(
DW
)] key to activate Preset Channel Scan.
2. Press and hold down the [ SCAN
(
DW
)] key until the radio beeps one time.
The radio is now scanning the Preset channels and the Priority channel.
3. The Priority Channel will be scanned in between each Preset channel.
Example: Let us say marine channels “22A”, “68”, and “88A” are saved as
preset channels. Priority scanning will proceed in the following sequence:
[
CH22A
]
[ Priority Channel
]
[ CH68
]
[ Priority Channel
]
[
CH88A
]
[ Priority Channel
]
[ CH22A
]
[ Priority Channel
] .....
4. Press and hold the [ SCAN
(
DW
)] key for three seconds to return to the
Preset Channel Scan operation, if desired.
5. To stop the Preset Priority Scanning, press the [ SCAN
(
DW
)] or [
CLR
(
WX
)] key.
6.10 MEMORY SCAN
The HX751 can be programmed to scan channels from a minimum of 2 chan-
nels up to all channels in the marine band, PRESET channels and NOAA
weather channels. If an incoming signal is detected on one of the channels
during scan, the radio will pause on that channel, allowing you to listen to the
incoming transmission.
6.10.1 PROGRAMMING
1. With the radio on press the [ 16/9
] key to select working channels.
2. Turn the transceiver off.
3. Hold down the [
SQL
] key, and then turn on the transceiver while still hold-
ing down the [ SQL
] key.
4. The “ SEt ” will appear on the display, indicating that the Menu (“Set”) Mode
has been activated.
5. Press the [ SQL
] key to select the Menu Mode Item “
16 SCH ”.
6. Select the desired channel to be included in the scan memory using the
[ ] or [ ] key.
7. Press the [ CLR
(
WX
)] key to store the channel into the
transceiver’s scan memory and the “ oFF ” indication
changes to “ on ”.
NOTE
Channels stored in the Preset memory will be
shown with “
PST ” in the top right corner of the dis-
play when in the “ 16 SCH ” menu.
The Preset channels are always scanned. To re-
move a preset channel from scan the channel must be removed as a
preset channel, refer to section “
6.9.1 PROGRAMMING ”, sentence 4.