Standard Horizon HX290E, Руководство пользователя

Страница: 22 / 40

HX290E
Page 22
6.8 SCANNING
The
HX290E
has two modes for scanning channels. Memory Scan and Prior-
ity Scan.
Memory Scan Mode will scan the channels programmed into the Preset in-
stant access channels and programmable Scan Channel Memories.
Priority Scan mode will scan the same channels as Memory Scan Mode and
also Channel 16 as the Priority Channel.
When an incoming signal is detected on one of the channels during scan, the
transceiver will pause on that channel, allowing you to listen to the incoming
transmission. The transceiver will automatically start scanning again after the
transmission stops.
6.8.1 SELECTING THE SCAN TYPE
1. Turn the transceiver off by rotating the
VOL
knob fully
counter-clockwise.
2. Hold down the key, and then turn on the transceiver
while still holding down the key.
3. “
SEt SEt
SEt SEt SEt
” will appear on the display, indicating the Menu
(“Set”) Mode has been activated.
4. Press the key, repeatedly if necessary to select the
Menu item “
SC SC SC SC SC
”.
5. Press the or key to select “
PS PS PS PS PS
(Priority Scan)” or
“
MS MS MS MS MS
(Memory Scan)”. The factory default is “
PS PS PS PS PS
(Priority
Scan)”.
6. After completing your selection, turn the transceiver off
and on by rotating the
VOL
knob.
7. See section 6.8.2 for instructions on adding memory channels to the
Memory Scan mode and section 6.8.3 on how to initiate a Memory Scan.
8. See section 6.7 for instructions on adding channels to the Preset instant
access channels and section 6.8.4 on how to initiate a Priority Scan.
“M
EMORY
” S
CAN
Preset
Channel “4”
Preset
Channel “3”
Preset
Channel “0”
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel “1”
Preset
Channel “2”
“P
RIORITY
” S
CAN
Preset
Channel “4”
Preset
Channel “3”
Preset
Channel “0”
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
Preset
Channel “1”
Preset
Channel “2”