Page 127
CPV550
4. Speak slowly and clearly into the microphone, hold the microphone about 1/2 inch away
from your mouth.
5. When finished, release the
[PTT]
switch.
6. To exit the “INTERCOM” mode and return to radio operation mode, press the
[F]
key
followed by the
[5(IC)]
key again.
22.2.1 Calling
Press and hold the [5(IC)] key for 1 second when the “INTERCOM” operation is activated,
a calling beep is emitted from the CPV550 speaker.
22.3 MANUAL INPUTTING OF THE GPS LOCATION (LAT/LON)
You may send the Latitude/Longitude of your vessel manually from the VH-310 Handset
even if the CPV550 is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or Position
Send will contain the manually entered position.
1. Press and hold down the
[CALL(MENU)]
key until “Radio Setup” menu
appears.
2. Press the
[
T
]
key to select “DSC SETUP” menu.
3. Press the
[ENT]
key, then select “POS INPUT” with the
[
T
]
/
[
S
]
key.
4. Press the
[ENT]
key then, enter the your local time from the keypad by
the 24-hour system on the UTC time.
5. Enter the Latitude of your vessel location (xx.xx.xx) by the keypad, then
press the
[6(NAV)]
key to select North (N), or
[7(SCRM)]
key to select
South (S).
6. Enter the Longitude of your vessel location (xxx.xx.xx) by the keypad,
then press the
[3(SCAN)]
to select East (E), or
[9(FOG)]
key to select
West (W).
7. If a number was entered by mistake, press the
[H/L]
key repeatedly to
select the number. Press the
[
T
]
/
[
S
]
key to select the desired number.
8. Press and hold in the
[ENT]
key to store the data entered, then press the
[16/9]
key to exit this menu and return to radio operation mode.
