Stamina SlimStriderX 55-9163, Руководство пользователя

Страница: 14 / 24

The safety and integrity designed into the SlimStriderX
TM
can only be maintained when the SlimStriderX
TM
is regularly examined for damage and wear. Special attention should be given to the following:
1. Over time the PIVOTING JOINTS(16) may squeak during workout. Lubricate the PIVOTING
JOINTS(16)
with general purpose lithium grease in “clear” spray formula. Lubricant may accumulate
on the outside of the PIVOTING JOINTS(16). If this occurs, wipe off with absorbent towel.
2. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
3. Verify that the WARNING LABEL(56) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement
WARNING LABEL(56)
if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the SlimStriderX
TM
removed from
service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the SlimStriderX
TM
.
7. Keep your
SlimStriderX TM
clean by wiping it off with an absorbent cloth after use.
8. Prior to performing any exercise shown in the manual and DVD please make sure you are coordinated
and comfortable enough for them to be performed. Please always use caution and your best judgment
prior to attempting any of the exercise programs.
MAINTENANCE
14
OPERATIONAL INSTRUCTIONS
SAFETY PRECAUTIONS
The remarkable design of the SlimStriderX
TM
allows the
PEDALS(14, 15) to move front and back as well as side
to side freely. Be careful to maintain your balance while
using, mounting, and dismounting. Follow the instructions
below to safely operate the SlimStriderX
TM
:
1. To maintain your balance, always hold the
HANDLEBARS(9, 10) with both hands while using,
mounting, and dismounting.
2. In order to avoid use by someone unfamiliar with the
SlimStriderX
TM
, always fold up the PEDAL ARMS(8)
and lock in position with the LOCKING PINS(31) as
shown.
LOCKING PIN(31)