Stamina SlimStrider 360 55-9162, Руководство пользователя

Страница: 14 / 24

The safety and integrity designed into the
SlimStrider 360
TM
can only be maintained when the
SlimStrider 360
TM
is regularly examined for damage and wear. Special attention should be given to the
following:
1. Over time the PIVOTING JOINTS(16) may squeak during workout. Lubricate the PIVOTING
JOINTS(16) with general purpose lithium grease in “clear” spray formula. Lubricant may accumulate
on the outside of the
PIVOTING JOINTS(16). If this occurs, wipe off with absorbent towel.
2. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
3. Verify t
hat the WARNING LABEL(56) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(56) if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the SlimStrider 360TM removed from
service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the SlimStrider 360TM.
7. Keep your SlimStrider 360™ clean by wiping it off with an absorbent cloth after use.
8. Prior to performing any exercise shown in the manual and DVD please make sure you are coordinated
and comfortable enough for them to be performed. Please always use caution and your best judgment
prior to attempting any of the exercise programs.
MAINTENANCE
14
OPERATIONAL INSTRUCTIONS
SAFETY PRECAUTIONS
The remarkable design of the
SlimStrider 360
TM
allows
the PEDALS to move front and back as well as side to
side freely. Be careful to maintain your balance while using,
mounting, and dismounting. Follow the instructions below
to safely operate the
SlimStrider 360
TM
:
1. To m a i n t a i n y o u r b a l a n c e , a l w a y s h o l d t h e
HANDLEBARS with both hands while mounting and
dismounting.
2. In order to avoid use by someone unfamiliar with the
SlimStrider 360
TM
, always fold up the
PEDAL ARMS(8)
and rotate the swing arm towards the back and insert
the
LOCKING PINS(31)
as shown.
LOCKING PIN(31)