The safety and integrity designed into the
BodyTrac Glider 1060
can only be maintained when the
BodyTrac Glider 1060
is regularly examined for damage and wear. Special attention should be given to
the following:
1. Pull on the
HANDLEBARS(17, 18)
and verify that the
SHOCK(22)
provides tension.
2. Clean the roller tracks in the
CENTER BEAM(1)
with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the
CAUTION LABEL(62)
is in place and easy to read. Call Stamina Products immediately
at
1-800-375-7520
for a replacement
CAUTION LABEL(62)
if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the
BodyTrac Glider 1060
removed
from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the
BodyTrac Glider
1060.
8. Keep your
BodyTrac Glider 1060
clean by wiping it off with an absorbent cloth after use.
MAINTENANCE
13
LOAD ADJUSTMENT
The resistance of the shock can be adjusted by twisting the adjustment
knob at the top of the shock. There are settings from 1 to 12. Setting #1
will provide the lowest resistance. Setting #12 will provide the highest
resistance.
CAUTION:
The shock gets
HOT
after a few minutes of use.
Adjustment
Knob
Mark
OPERATIONAL INSTRUCTIONS
PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can change to attach the
PEDAL STRAP(35)
to the
lower position in the
PEDAL CAP(34)
as shown in illustration 1 below. Run the
PEDAL STRAP(35)
through
the opening from the bottom of the
PEDAL CAP(34).
Pull the
PEDAL STRAP(35)
to make the Knot against
the bottom of the
PEDAL CAP(34).
Run the
PEDAL STRAP(35)
through the opening in the
PEDAL CAP(34)
on the other side from the top as shown in the illustration 1, then make the end of the
PEDAL STRAP(35)
go up to attach onto the upper part of the
PEDAL STRAP(35)
with the Hook & Loop Pad.
Attach the end of the
PEDAL STRAP(35)
to different position with the Hook & Loop Pad to adjust the length.
Refer to illustration 2.
Hook & Loop Pad
Hook & Loop Pad
Knot
1.
2.
End of Pedal Strap
Содержание BODYTRAC GLIDER 1060
Страница 3: ......
Страница 18: ...PRODUCT PARTS DRAWING 18 FRONT BACK...
Страница 21: ...NOTES 21...
