ASSEMBLY INSTRUCTIONS
7
STEP 3
Refer to the inset drawing. Lay the
UPRIGHT(5)
on the floor close to the front of the
MAIN FRAME(1).
Set
the
TENSION KNOB(23)
on the
UPRIGHT(5)
at position
"8",
so the cable end extends out of the metal
fitting as far as possible. Connect the
CABLE END
of the
TENSION KNOB(23)
into the
SPRING HOOK
on
the end of the
TENSION CABLE(22).
Pull the
CABLE
on the
TENSION KNOB(23)
firmly and insert the
cable through the slot in the bracket. Then insert the
METAL FITTING
on the end of the
CABLE
of the
TENSION KNOB(23)
into the hole at the end of the slot in the
BRACKET.
Adjust the
TENSION KNOB(23)
and verify that the
SPRING HOOK
moves when the
TENSION KNOB(23)
is adjusted.
STEP 4
Plug the
SENSOR WIRE(28)
firmly into the
CONNECTION WIRE(27).
CAUTION:
Be careful not to damage
the
SENSOR WIRE(28)
and
CONNECTION WIRE(27)
when assembling the
UPRIGHT(5).
STEP 5
Insert the
UPRIGHT(5)
onto the
MAIN FRAME(1)
and secure with
BUTTON HEAD BOLTS
(M8x1.25x15mm)(63), ARC WASHERS(M8)(87),
and
LOCK WASHERS(M8)(89). Do not tighten the
bolts until STEP 10.
Bracket
Cable End
Spring Hook
Metal Fitting
Содержание 55-1771
Страница 18: ...PRODUCT PARTS DRAWING 18 FRONT BACK...
Страница 21: ...21 NOTES...
