3.1 Power Supply
To supply power for the STALKER X-S01 Professional trail camera, four or eight AA
size batteries are needed.
Open the bottom cover. Confirm that the power switch is at the OFF (Right) position,
pull out the battery compartment and load the fully charged batteries into the
compartment accordingly to the polarities sign shown below. Push back the battery
compartment in to the battery chamber.
The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries (Recommended)
2. Rechargeable alkaline batteries
3. Rechargeable NiMH batteries
There are four battery slots. Slot 1 and 2 form one group (“1” will mark on the
depot), while slot 3 and 4 form the other group (“2” will mark on the depot) where each
group can supply the power individually.
When in Test Mode, camera will be automatically shut down to save power if not in
operation within 3 minutes; it will wake up by any movement detection.
When in low-battery state, camera will automatically shut down. Please change the
batteries once this happens.
3.2 Insert the SD-card
Insert SD-card into the card slot with marked side upwards.
Please note that the SD-card can only be plugged in one direction. Make sure that
the write-protect switch of the SD-card is on the “write” position.
3.3 Power on and Enter into the ON Mode
Before switching on, please pay attention to the following:
1. Avoid temperature and motion disturbances that could be construed as animals
or humans such as trees that are exposed to direct sunlight for much of the day or any
other heat source. These may cause false triggers
2. The height from ground for placing the camera should ideally be 1 meter, but 2
meter is preferred. Slide the power switch to the “ON” position to turn on the camera
and enter into the “ON” mode.
After switching on the camera, the motion indication LED (red) will blink for about
15s. The 15s is a buffering time before automatically capturing photos or videos, e.g. for
closing and locking the bottom cover, fixing the camera on a tree and walking away.
In “ON” mode, the camera will take pictures or videos automatically according to
the default settings or previous custom settings. The STALKER X-S01 Professional trail
camera has a high sensitivity mic for high quality sound recording, so the sound will be
embedded in the video clip while capturing a video.
3.4 Enter into the TEST Mode
Slide the power switch to the “TEST” position to enter into the TEST mode. There
are some functions in TEST mode: Custom settings, manual capture, preview.
All manuals and user guides at all-guides.com