PL
EN
29
Clutch (Fig. D)
Your tool has an adjustable torque screwdriver mechanism for driving and removing a
wide array of fastener shapes and sizes, and a hammer mechanism for drilling into
masonry. Circling the collar (3) are numbers while (4) are symbols “ ” driver,“
”
drill and “ ” hammer. When you use the tool as a driver, adjust “ ” aligned with the
triangle mark, then choose the numbers in (3). The higher the number on the collar, the
higher the torque and the larger the fastener which can be driven. When your use the
tool as drill or hammer, adjust the “
” or “
” aligned with the triangle mark
accordingly.
High-Low Mechanical Switch (Fig. D)
The speed feature of your tool allows you to shift gears for greater versatility. To select
speed 1 (highest torque setting), turn the tool off and permit it to stop. Slide the gear
shifter
(4) all the way to the forward, Speed 2 (highest speed setting) is to the back
NOTE:
Do
not change gears when the tool is running. Always allow the drill to come to a complete
stop be- fore changing gears. If you have trouble charging gears, make sure that the
gear shifter is engaged in one of the two speed settings.
Keyless Single Sleeve Chuck (Fig. E)
Your tool features a keyless chuck (5) with one rotating sleeve for one-handed
operation of the chuck. To insert a drill bit or other accessory, follow these steps.
1. Lock the trigger in the OFF position as described on "Forward/ Reverse Slider" section
above.
2. Grasp the black sleeve of the chuck with one hand and use the other hand to secure
the tool as shown in Figure E. Rotate the sleeve counterclockwise far enough to accept
the desired accessory.
3. Insert the accessory about 19 mm (3/4") into the chuck and tighten securely by
rotating the chuck sleeve clock- wise with one hand while holding the tool with the
other.
Your tool is equipped with an automatic spindle lock mechanism. This allows you to
open and close the chuck with one hand.
To release the accessory, repeat step 2 above.
WARNING:
Do not attempt to tighten drill bits (or any other accessory) by gripping
the front part of the chuck and turning the tool on. Damage to the chuck and pers- onal
injury may result. Always lock off trigger switch when changing accessories. Be sure to
tighten chuck with one hand on the chuck sleeve and one hand holding the tool for
maximum tightness.
Operation as a Drill
Always observe the safety instructions and applicable regulation.
• Make sure your battery is (fully) charged.
• Turn the collar (3) to the drill bit symbol.
• Install and tighten the desired drill bit in the chuck
• Select the desired speed/torque range using the gear shifter (4) to match the speed
ORIGINAL INSTR
UCTION