PL
EN
25
ASSEMBLY AND ADJUSTMENT
Prior to assembly and adjustment, always remove the battery pack.
Always switch off the tool before inserting or removing the battery pack.
Use only UB80SA battery packs and charger.
SAFETY INSTRUCTIONS FOR DRILL
(see Table 1)
- wear ear protectors with impact drill.
Exposure to noise can cause hearing loss.
- Use auxiliary handle supplied with the tool.
loss of control can cause personal injury.
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY PACKS
The battery pack is not fully charged out of the carton.
Do not carry extra battery packs in aprons, pockets, or tool boxes along with other
metal objects.
Battery pack could be short circuited causing damage to the battery
pack and possibly causing severs burns or re.
Do not incinerate the battery pack even if it is severely damaged or is completely
worn out.
The battery pack can explode in a re.
• A small leakage of liquid from the battery pack cells may occur under extreme usage
or temperature conditions. This does not indicate a failure. However, if the outer seal is
broken and this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If battery liquid gets into your eyes, ush them with clean water for a minimum of 10
minutes and seek immediate medical attention. (Medical note: The liquid is 25-35%
solution of potassium hydroxide.)
• Charge the battery packs only in UB80SA chargers.
•
NOTE:
The batteries in your battery pack are the lithium- ion type. lithium is considered
to be a toxic material by the Environmental Protection Agency. Before disposing of
damaged or worn out Li-ion- battery packs, check with your local Environmental
Protcetion Agency to nd out about special restrictions on the disposal of these battery
packs.
•
DO NOT
store or use the tool an battery pack in locations where the temperature may
reach or exceed 45°C(105°C) (such as outside sheds or metal buildings in summer).
•
DANGER:
Never attempt to open the battery pack for any reason. If battery pack
case is cracked or damaged, do not insert into charger. Danger of electric shock or
electrocution.
BATTERY PACKS
Your tool uses either a 14.4 or 18 Volt battery pack. When ordering replacement battery
packs, be sure to include catalog number and voltage: Extended Run-Time battery
packs deliver 25% more run-time than standard battery packs.
NOTE:
Your tool will accept either standard or Extended Run Time battery packs.
However, be sure to select proper voltage.
• Before using battery charger, read an instructions and cautionary markings on
battery charger, battery and product using battery.
ORIGINAL INSTR
UCTION