PL
EN
27
• Do not operate charger with damaged cord or plug-havethem replaced
immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to an authorized service center.
• Do not disassemble charger; take it to an authorized service center when service or
repair is required. In correct reassembly may result In a risk of electric shock,
electrocution or re.
• To reduce risk of electric shock, unplug charger from outlet before attempting any
cleaning. Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together
• The charger is designed to operator on standard household electrical power and
one specify voltage only. Always check that the power supply corresponds to the
voltage on the rating plate.
Labels on charger and battery pack
In addition to the pictographs used in this manual, the labels on the charger and the
battery pack show the following pictographs:
Battery charging
Battery charge
Replace Pack
Problem Power Line
Do not charge damaged battery packs
Read instruction manual before use
Discard the battery pack with due care for the environment
Do not incinerate the battery pack
Before using the driver drill, charge the battery as follows.
1 . Insert the battery Into the charger.
To make sure the anode and cathode of battery aim at the anode and cathode of
charger, and insert the battery until the battery connect the bottom of charger. Both
battery and charger are marked anode “+” and cathode “-”.
2. Connect the charger power cord to the receptacle. Connecting the power cord will
turn on the charger. (the light will be on red). About charging time "at 20°C"
* 1- Hour charger
The battery will be full charged at about 1 hour (the light will be turn green).
3. Disconnect the charger power cord from the receptacle.
4. Hold the charger tight and pull out the battery.
CHARGING
Output Voltage
Rated capacity
Model
ORIGINAL INSTR
UCTION
Table 1