Stairmaster FreeClimber, Руководство по обслуживанию

Страница: 55 / 113

Page 56
SYMPTOM : COMPRESSOR SHUTS OFF BEFORE REACHING PROGRAMMED LEVEL
1. Possible air leak. Console will shut off compressor if the accumulator pressure does not drop off the
top bar graph light in 20 seconds. Console will light up again after another 10 seconds. Compressor s
hould reach 40 PSI in 18 seconds. Watch pressure gauge and time compressor. If it does not reach this
level, the compressor will shut itself off.
SYMPTOM : FREQUENT LEAKS BETWEEN COMPRESSOR AND CHECK VALVE
1. Mechanical lift is hitting a hose during operation, usually at or near floor level.
SYMPTOM : CYLINDER HAS NO TOP OR BOTTOM CUSHION
1. Cylinder has a bad internal check valve, replace cylinder.
SYMPTOM : PLATFORM STICKS IN THE MIDDLE OF LEVELS 1 OR 2
1. Is user inputting his weight correctly? Are other people having the same problem?
2. Possibly too much mechanical friction. Lubricate oilite bushings with 30W oil.
SYMPTOM : AT THE END OF WORKOUT OR WHEN MACHINE IS POWERED UP, CONSOLE FLASHES ZEROS 4
TIMES
1. Power module is too far out of zero, adjust power module. Perform calibration proceedure.
SYMPTOM : COMPRESSOR WILL NOT RUN AT ALL
1. Plug compressor directly into a 110 VAC wall outlet. If it doesn’t work, replace compressor.
2. If compressor does work when plugged into a 110 VAC wall outlet, unplug the compressor and the
solenoid from the power module. Next, plug the compressor into the solenoid receptacle on the power
module. If the compressor works, replace the power module.
SYMPTOM : SOLENOID VALVE STAYS OPEN ALL THE TIME
1. Unplug valve from power module and check if the machine will pressurize. If machine does not
pressurize when valve is unplugged, replace it.
SYMPTOM : MACHINE MAKES SQUEAKING NOISES
1. Lubricate oilite bushings with 30W oil.
SYMPTOM : DURING EXERCISE, BOTTOM LEVEL OF PLATFORM TOO HIGH OR TOO LOW
1. Adjust safety valve.
2. If safety valve is adjusted properly, replace cylinder.