Stahl ISpac 9143/10-065-150 0 Series, Руководство по эксплуатации

Страница: 14 / 24

Operating instructions english
14
I.S. Power Supply Type 9143
6 Arrangement and fitting
6.1 Dimension drawing
6.2 Installation
The I.S. power supply is to be installed outside of the explosion hazard area.
6.3 Mounting and dismounting
a) Detachable terminals
All devices are provided with detachable terminals. A screwdriver is
needed to remove the terminals (as shown in the picture).
b) Mounting on DIN rails
Set the device on the DIN rail and tilt/snap onto the rail as depicted.
Do not tilt at an angle to either side when mounting. To dismount,
use a screwdriver to gently pry up the lock on the mounting foot and
then remove the module.
c) Mounting on DIN rails with an already-installed pac-Bus (only 9143/10-...-...-10)
As depicted in the photo, set the device in position on the pac-Bus
(already mounted on the DIN rail) and tilt/snap until it locks in.
Do not tilt at an angle to either side when snapping onto the pac-Bus.
Note: In order to prevent pole reversal during installation, the pac-Bus
elements have been equipped with a keyed connection plug (see photo).
The module is fitted with a matching slot.
Dismount as described below in b).
Size X
Screw terminals 108 mm
Spring clamp terminals 128 mm
Insulation displacement
Connectors 131 mm
11
4
,5
1
2
2