Stahl HORN, Инструкция по эксплуатации

Страница: 22 / 28

Commissioning
8 8491602300
S-BA-8491/2-02-en-11/04/2007
Horn
8491/2
X
Unlock the screwless terminal with a screwdriver and insert the wires into the
appropriate terminal clamps (2).
X
Check the wires to see if they are connected properly.
X
Replace the seal and cover plate and close tightly using the four screws.
9.2 Replace the front
11094E00
X
Insert the seal supplied.
X
Place the front on the horn and rotate it clockwise by about 15° (1).
X
Tighten the screw securely to close the horn (2).
10 Commissioning
Before operation
X
Check the wires to see if they fit tightly in place.
X
Check to make sure that all seals are in place.
X
Check the enclosure for damage.
X
Observe the nominal voltage specification.
X
Check to see if the proper back-up fuse is installed.
X
Check the cable glands to see if they are tight and seal properly.
X
The horn may only be operated when completely assembled.
During operation
)
The horn can be switched on and off during operation.
There are no other operating states.