Product selection, project engineering and modification
8
255118 / 815060300340
2017-04-19·BA00·III·en·01
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal box
Series G150/1
5.1
Additional through holes in flange plates
5.1.1 Creation of additional drilled holes and through holes by R. STAHL
Forward the following information to R. STAHL:
- Type
- Data sheet
- Quantity, manufacturers and approvals of the components that are to be installed.
R. STAHL
• will check whether the components, drilled hole diameters, quantity and position
correspond with the approval
• will create the drilled holes and through holes
• will mount the components
• will update the order documentation
• will carry out a routine test
• will, if necessary, fit a new type plate if the technical data has changed, e.g. due to the
components that are to be additionally installed.
5.1.2 Ascertaining the usable area for cable entries in flange plates
18104E00
Collision frame and earth connection of flange plate
Select a space/area for the cable entry on the flange plate anywhere inside the collision
frame (see thin line in figure). Ensure that screw connections made later do not go beyond
this collision frame.
Observe the following conditions when doing so:
Leave enough distance to the circumferential seal (min. 2 mm) (see detail in figure).
Leave enough distance to the earth connection (min. 10 mm) (see bottom of figure).
5.1.3 Creation of additional drilled holes and through holes by the customer
Modify the device carefully and only in accordance with the safety notes
(see chapter "Safety").
Calculate the usable area, see section 5.1.2.
Create additional through holes by lasing or punching (drilling, hole cutting).
Ensure that the surfaces remain flat during punching and cutting.
Determine the core hole diameter for threads. Do not use an NPT thread!
When determining the through holes, observe the mounting distances.
Adjust the hole diameters to the dimensions of the built-in parts or their seals.
The use of built-in components with flat seal (gasket) is preferred.
Observe section 5.3 when subsequently equipping components!
2 [0,08]
10 [0,39]
2 [0,08]
