Stahl ConSig 7040 Series, Руководство по эксплуатации

Страница: 37 / 40

125711 / 704060300010
2019-02-19·BA00·III·en·04
Commissioning
17
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Control Unit System
Series ConSig 7040
8 Commissioning
Before commissioning, ensure the following:
• Check the mounting and installation.
• Inspect the enclosure for damage.
• Remove any foreign bodies.
• If necessary, clean the connection chamber.
• Check if the conductors have been inserted correctly.
• Check if all screws and nuts have been tightened firmly.
• Check whether all the cable entries and stopping plugs have been tightened firmly.
• Check if all conductors have been clamped firmly.
• Make sure that unused cable entries are sealed using plugs with appropriate
certification and unused drilled holes are sealed with appropriately certified
stopping plugs.
9 Maintenance, Overhaul, Repair
9.1 Maintenance
• Consult the relevant national regulations to determine the type and extent of
inspections.
• Adapt test intervals to the operating conditions (installation site, weather conditions,
utilisation rate of the systems, operating errors, manufacturer's specifications in the
technical documentation, changes in the entire system).
At a minimum, check the following points during maintenance work on the device:
• Whether or not the clamping screws holding the electric lines have been firmly
tightened,
• If the enclosure, actuators and seals are damaged,
• Compliance with the permissible temperatures (in accordance with IEC/EN 60079).
DANGER
Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation before commissioning.
• Comply with national regulations.
You must not carry out maintenance work on built-in elements with
flameproof enclosures. In case of damage, replace the built-in element.