227865 / 9185612310
2016-04-15·BA00·III·en·03
Mounting and installation
15
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Fieldbus Isolating Repeater
Series 9185
8.2.2 Mounting / dismounting pluggable terminals
All devices are equipped with pluggable terminals.
Mounting
• Plug the terminal into the device until the terminal engages.
Dismounting
8.3
Installation
8.3.1 Electrical connections
• Follow the information provided in the section on "Technical Data".
• The conductor must be connected carefully.
• The conductor insulation must reach the clamping units.
• Do not damage the conductor (nicking) when stripping it.
• Ensure that the maximum permissible conductor temperatures and the maximum
permissible surface temperature are not exceeded by selecting suitable electric lines
and means of running them.
• Avoid mechanical damage to the conductor insulation due to rubbing against
sharp-edged or moving metal parts.
• Make sure that the correct tightening torque is used (0.5 to 0.6 Nm).
8.3.2 Schematic diagram
See manual 9185.
8.3.3 Compatibility at the PROFIBUS DP Ex i (9185/11-35-10)
See manual 9185.
8.3.4 Compatibility at the PROFIBUS RS-485 IS (PNO) and RS-485 Ex i (STAHL)
(9185/11-35-10)
See manual 9185.
8.3.5 Connection and plug assignment overview
See manual 9185.
10859E00
• Position the screwdriver behind the terminal.
• Push out the terminal.
Operation under difficult conditions, such as, in particular, on ships,
requires additional measures to be taken for correct installation, depending
on the place of use. Further information and instructions on this can be
obtained from your regional sales contact on request.
