Mounting and Installation
12
132999 / 8102604300
2018-10-18·BA00·III·en·06
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Junction Boxes
Series 8102
7.2
Mounting / Dismounting, Operating Position
7.2.1 Assembly
This device is suitable for outdoor and indoor use.
• Provide a protective roof or wall if the enclosure and explosion-protected electrical
equipment are used outdoors.
DANGER
Explosion hazard due to open holes and unused cable entries!
Non-compliance results in severe or fatal injuries.
• Always close open holes and unused cable entries using approved
stopping plugs or plugs.
• When selecting cable entries, observe the thread type and thread
size in the equipment documentation.
DANGER
Explosion hazard due to non-compliance of information on the rating
plate!
Non-compliance can result in severe or fatal injuries.
• Operate the devices only within the technical data designated on
the rating plate.
WARNING
Mechanical overload of the device!
Non-compliance can result in severe or fatal injuries and material
damage.
• Install protective wire grid.
• Install the device only in locations with little vehicle and pedestrian
traffic.
16523E00
• Alignment of enclosure
depending on mounting type:
• For vertical mounting:
any alignment
• For horizontal mounting:
cover on top
• Hanging position/overhanging
cover is not permitted!
≦ 90°
