07
11. FACTORY VALUE RESET
The motor performs two
brief upward movements
to indicate that it was
reset.
H
All rights reserved.
STAFER S.p.a. - via Malpighi, 9 - 48018 Faenza (RA) ITALY
Tel. (+39) 0546.624811 - Fax (+39) 0546.623141 - www.stafer.com
All products and technical specifications given in this document are subject to variation without prior notice.
Unless previously and specifically authorised by STAFER, the device must be used exclusively with transmitters produced by STAFER.
STAFER cannot be considered responsible for damage caused by improper, incorrect or unreasonable uses.
2 x UP
8 x DOWN
3 x UP
3 x DOWN
Within 15 seconds
press 3 times on
UP and 3 times on
DOWN.
C
(1)
Within 15 seconds
press twice on UP
and once on
DOWN.
E
(1)
the motor performs 6
up/down movements
OFF
ON
Switch OFF power supply for
few seconds, then switch it
ON again.
B
Bring the motor to the
intermediate position.
A
The motor completes
1 up/down movement.
D
F
When the anemometer is reset, all settings will return to factory values.
2 x UP
Within 5 seconds,
press UP twice
G
(1)
Notes:
ü
(1) Button must be pressed shortly, approx. 1 second between two pressures.
The device is provided with a diagnosis function of the wind sensor. If, for about 24 hours the wind sensor does not generate any valid pulse, the sensor
commands an automatic upward manoeuvre of the awning, suspends all other activities and indicates the fault by flashing the LEDs. The device will come out
of this state resuming normal activities only when the anemometer generates a valid pulse. To exit the alarm, remove and restore power. The function cannot be
deactivated.
09. ANEMOMETRIC TEST FUNCTION
10. ANEMOMETER CHECK ON AWNING STATUS
If the motor does not respond to the button commands, it is because some alarm has been activated. To understand the type of alarm, look at the colour of the
LEDs under the anemometer. Alternatively, it is also possible to “ask” the anemometer about the alarm status. The device will order the motor to perform some
movements corresponding to the active alarm. Proceed as follows.
01. Remove and restore power.
02. Press
UP
3
times
and
DOWN 3 times
*. The motor shows:
up/down.
03. Press
twice
on
UP
and 5
times
on
DOWN
. After 2 seconds, the
motor provides information on the awning's current status. See
table 3.
04. After 5 seconds, the motor returns to its initial position.
05. Wait for 10 seconds. The motor exits the menu without signalling.
USING THE WALL-MOUNTED BUTTON
No. of
movements
Alarm
2 lowering
3 x up
5 lowering
wind alarm
sun active
stopped due to
anemometric
test
Tab. 03 - Alarm status
Awning
position
Closed
Open
Closed
(*) The buttons must be pressed shortly, max 1 second between two pressures.
