Stadler Form Anna & Anna little, Руководство по эксплуатации

Страница: 9 / 36

• do not place the appliance near a heat source. do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• Please make sure that the used socket remains accessible.
• do not run the heater on an uneven or soft surface.
• CaUtIOn: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer.
• warnInG: In order to avoid overheating, do not cover the air inlet or air
outlet - fire hazard!
• do not use the heater in small rooms (below 4 m
2
in size), in explosive
environment, or for drying laundry.
• For indoor use only.
• do not store the appliance outdoors.
• do not touch the front grille, it might reach hot temperature.
• Use the heater only under supervision.
• do not insert any object and/or finger into the openings of the heater.
• to extinguish burning appliances only use fire blankets.
• If the supply cord or the appliance is damaged, it must be repaired/
replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Setup / operation
1. having set up the anna heater in the desired position connect the cable (9)
to the household supply socket.
2. switch on anna by clicking the on/off button (2)
3. Using the output button (3), you can control the heating output of anna:
a. Button in = 2000 w / 1200 w (little)
b. Button out = 1200 w / 700 w (little)
4. room thermostat (4): the room thermostat control allows a variable
temperature adjustment. setting: for maximum temperature turn to the left
(sun symbol), for minimum temperature, turn the control to the right (cold
symbol).
recommendation: turn the thermostat control to the left to the maximum. If
the desired room temperature has been reached, turn the thermostat control
to the right until the appliance switches off. If the room temperature drops,
then anna switches on again automatically. Please note that after the ther-
mostat switches off automatically, it takes a few minutes for the heater to
switch on again!
Note: Make sure that there is always sufficient space between the
appliance and the wall or other large objects. The air flow must not
be blocked by objects of any kind.
Cleaning
Before servicing the heater and after each occasion of use, switch off the
appliance and unplug the mains cable from the socket.
• Attention: never immerse the appliance in water (danger of short-
circuit).