40707-1608
3 14
INSTALLING THE BATTERIES
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
NOTE: If the batteries are low the indicator light will
flash blue when you start scanning. Replace with 4
new AA alkaline batteries as shown.
RECORDING FINGERPRINTS
To record a fingerprint, first press the Reset Button on
the inside of the safe. The scanner will turn blue with
two beeps (if the sound is turned on)and the blue
light flashes twice, you will then record the same
finger three times as follows:
1. Place your finger on the scanner until there
is one beep (if the sound is turned on) and the
green light flashes once. Lift your finger off
the scanner.
2. Place the same finger on the scanner for a
second time, holding the finger in the same
position until there is one beep (if the sound is
turned on) and the green light flashes once.
Lift your finger off the scanner.
3. Place the same finger on the scanner for a
third time, holding the finger in the same
position until there are two beeps (if the sound is
turned on) and the green light flashes twice.
Lift your finger off the scanner. Your fingerprint
is now recorded.
NOTE:
In certain dry climate conditions, your
fingerprint may not scan. If your fingerprint did not
scan, we recommend moisturizing with minimal
lotion and trying again.
SCAN THE SAME FINGER 3X
If the red light flashes three times with three beeps
(if the sound is turned on) your fingerprint did not
get recorded and you will have to start over.
If you try entering more than 20 fingerprints, the red
light will flash 5 times and there will be 5 beeps
(if the sound is turned on).
When you first receive your safe there are no recorded
fingerprints.
Any fingerprint will open the safe
until a fingerprint is recorded.
For security you
must record a fingerprint. Failure to do so will
compromise the safety and security of the safe. You
can record up to 20 different fingerprints for opening
the safe.
For best results, each individual should
use their thumb or index finger only.
After removing the drawer, push the battery cover
locking tab with a screwdriver to release the cover.
Install the (4) AA alkaline batteries as shown.
Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
