40261-1101
12
2
● For security you must program
your own combination after opening
the safe.
● Record this new combination on
this form.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
OPENING THE SAFE USING
YOUR COMBINATION
1.
2.
Press the Reset Button (5) located inside the safe. Two “beeps” will
sound.
1.
Enter your combination using the buttons. If 2 “beeps” sounds and the
green light goes on, the door will open. If an incorrect combination is
entered 4 short “beeps” will sound.
Example
:
(RIGHT) - (LEFT) - (CENTER) - (LEFT) - (RIGHT)
Enter your own 3-8 button combination by pressing any combination of
the 3 buttons. NOTE: A “beep” will sound when the button is
successfully pushed.
3.
Press the Reset Button again. After two “beeps” your new
combination is recorded.
NOTE: If you enter a wrong combination 3 times, the control pad
will lock out for 5 minutes.
IMPORTANT
Keep keys and your combination number in a secure place, away
from children. Keep this record of your serial number and
combination in a secure place separate from your safe. To order a
replacement key set, follow the instructions on the attached form.
STACK-ON PRODUCTS COMPANY
P.O. BOX 489
WAUCONDA, IL 60084
For best results this safe should be installed in an isolated, dry and secure area. For security the safe must be fastened to a
solid surface.
SELECTING A LOCATION
SECURING THE SAFE
Secure the safe to a permanent shelf using the holes and hardware provided.
Mark the holes to be used. Drill the appropriate diameter and depth of pilot holes depending on the type of hardware
being used and the type of mounting surface.
NOTE:
The safe needs to be upright and right side up or the locking mechanism will not function properly.
Secure the safe with the fasteners.
To close the safe, push the door closed until locked.
Reset Button
