Emergency kill switch
There is a “Kill switch” functionality that instantly cuts the power from the drone motors, for use
in dangerous situations as a last resort.To execute the “Emergency kill switch” press and hold
ڹ
ڹ
(up)
and
ۃ
(down)
at the same time for 3 seconds. This will make the drone cut all power
from the engines.
⚠
By activating the
Kill Switch
, the motors will instantly power off and the drone will
fall to the ground if it is in the air.
If the drone detects that it has crashed, it will
automatically turn off the motors to reduce damage.
Tracker Radio Signals
The tracker has multiple sensors inside to read your
movements, the GPS is the most important one. Illustration
shows where on the tracker that the wireless signals to the
Staaker is being sent from and the GPS location. These
locations should be unobstructed while flying the drone.
⚠
Loss of radio link will make the drone hold its
current position until radio link is recovered. If the
battery level on the drone is too low, the drone will land on its current position. If the
drone is in
Water Staak
mode or
Pro Staak
mode with
Return to Home
enabled it will
Return to Home
instead. If you fly the drone out of range in
Scenery
mode, the drone will
engage
Return to Home
.
⚠
If the tracker loses GPS signal the drone will stop following you and the drone will
enter
Scenery
mode under your control.
For optimal radio link range between drone and tracker, the wireless link on the
tracker should have clear line of sight to the drone.
18
