UM0857
Description of the STEVAL-IFS014V1 (smart monitoring station)
Doc ID 16752 Rev 1
27/66
4.3.6
Setting the various warning alarms
The user can set the maximum and minimum values of various weather parameters as
alarm conditions for the different nodes. For this user should perform the following steps:
1.
Go to the "WARNING ALARMS" menu using the various menu options available (see
)
2.
Select the parameter whose maximum/minimum values are to be configured
3.
The screen for the configuration of the maximum/minimum values of the parameter
selected is displayed on the screen
4.
The user can enter the values using the navigational options available on the screen
(these are same as those of “set system time“)
5.
If the values entered by the user are not valid, an error message is displayed on the
screen and the system exits the menu
6.
If the values entered are valid, then the system moves to the "SELECT NODE" menu.
The user can select any node of the parameter to be configured or “NODE 0” for the
smart monitoring station
7.
If the node selected by the user is not active, then an error message is displayed on the
screen and the system exits the menu
8.
If the node selected is active, then the warning condition of that particular node for that
particular parameter is configured.
Note:
The maximum value of any parameter should be greater than the minimum value.
4.3.7
No-display mode (power saving)
If the user does not want to see the display and wants to save the power, there is a provision
to switch off the backlight of the display.
The user should perform the following steps:
1.
Go to the "B. LIGHT OFF" option of the menu using the various menu options (see
)
2.
Upon selecting this option, after 15 seconds the backlight of the display turns off and
the display is not visible to the user
3.
The system exits this mode and the display resumes by simply touching the screen
4.
If after selecting this option, the user wants to change his/her decision before 15
seconds, he/she can go to the menu of "B.LIGHT OFF" and select this option. In this
case the system does not enter the no-display mode.
4.3.8 System
restore
The user can configure the system for the following settings:
Delete node
The user can delete the details of the node which are already stored in the system. The
system deletes the node details and that space is freed for the new node. If the same node
rejoins the system, then the user re-assigns the node number to that node.
Note:
Only those nodes whose information is stored in the station and are not active can be
deleted.
www.BDTIC.com/ST
